Sale

EOTech AN / PEQ 2A Battery IR Laser Aiming Device & Illuminator Flashlight Combo

$1,495.00

  • Class IIIb, 835nm infrared laser
  • 50mW / 3.5mW output modes
  • 1-105mrad adjustable beam width

Out of stock

SKU: 19435 Categories: ,

Description

  • The US Military Standard for Night Direct Fire
  • IR Aiming Laser for First Shot Hit Capability
    • Range >2,000 Meters
    • IR Illuminator for target Detection
    • Adjustable Beam (Spot to Flood)
  • Battle-Tested
    • Iraq
    • Afghanistan
  • Over 100,000 Produced for the U.S. Military
  • Mounts to any MIL-STD-1913 Rail
    • M4
    • M240
    • M249
    • All U.S. Military Standard Direct Fire Weapons
  • Waterproof to 66′

The AN/PEQ-2 succeeded the AN/PAQ-4C, which was designed in the early 1990s after the Persian Gulf War.[2]

The device, which is mil-spec, is still seeing active service but is being withdrawn and replaced amongst U.S. Armed Forces. It was also part of the U.S. SOPMOD kit, though the device is being replaced by the new smaller AN/PEQ-15 (ATPIAL) model.[3]

Operation[edit]

The AN/PEQ-2 has two infrared laser emitters—one narrow beam used for aiming the rifle, and one wide beam used for illuminating targets, like a flashlight.[4] The beams can only be seen through night vision goggles.[4] Each beam can be zeroed independently, and the illuminator’s radius is adjustable. The two lasers are tied into one 6-mode switch, which has the following modes:

Mode Marking Targeting laser IR illuminator
0 OFF off off
1 AIM low power off
2 DUAL LO low power low power
3 AIM HI high power off
4 DUAL LO/HI high power low power
5 DUAL HI high power high power

Turning the mode switch does not turn on the lasers. A recessed button on top of the device is tapped once to briefly turn on the lasers or tapped twice to turn the lasers on until deactivated, either by pressing a third time or by turning the mode switch to off. Additionally, an extra pressure switch can be plugged into the rear of the device and then placed virtually anywhere, limited only by the length of the pressure switch’s cord; typically one to two feet. This pressure switch operates the same way as the recessed button.[5]

The AN/PEQ-2A upgrade incorporates a blue removable safety block which physically prevents turning the mode switch to any of the high power modes, which are capable of causing eye damage. Both variants are waterproof to a depth of 20 meters and run on two AA batteries. Additional civilian variants also exist—they can provide greater power, visible/IR laser combinations, or other features.[5]